| Measuring range | 0.0mS/m-199.9S/m
Preset measuring range: 0.0-199.9mS/m, 0-1999mS/m,
0.00-19.99S/m, 0.0-199.9S/m (Conductivity can be shown in %) |
| Power source | AC90 - 240V 50/60Hz 25VA |
| Input | Sensor input | Electromagnetic conductivity sensor |
| Temp. input | 0-99.9˚C (Pt1000Ω) |
| Pump stop input | No-voltage contact signal (Max applied voltage: DC5V 5mA) Pump stops when signal is inputted. |
| Output | Pump output | No-voltage contact: 1N/Ox1 AC240V 0.1A
ON/OFF operation control (Upper/Lower motion): 0.0mS/m-199.9S/m
Pulse proportional control: 0.0mS/m-199.9S/m between 0-360spm |
| Alarm output | No-voltage contacts: 1N/O×1 AC250V 10A Resistive load
Upper/Lower limit alarm: 0.0mS/m-199.9S/m Select 2 lines between AL1-4
Hysteresis width: 0.1mS/m-199.9S/m
Delay time:0-99 seconds |
Transmission output
(Conductivity) | DC0-20mA Load resistance 500Ω or below.
Isolated type (can be set between 0.0mS/m-199.9S/m arbitrarily)
"Continuous out put" or "hold" excepting control mode. |
Transmission output
(Temperature) | DC0-20mA Load resistance 500Ω or below.
Isolated type (can be set between 0.0˚C-99.9˚C arbitrarily)
"Continuous out put" or "hold" excepting control mode. |
| Function | MAN calibration | Calibration in the air and 1 point calibration |
| Measured value shift range | Temperature: ±50˚C Concentration: ±50.00% |
| Concentration curve selection | Preset data: NaCl(0-20%), HCI(0-15%), NaOH(0-10%), H2SO4(0-25%)
Optional straight and curve line data can be stored 1 each. |
| Error message | Out of measuring range (conductivity, concentration, or temperature)/ Wrong setting/ Error in calibration in the air. |
Catalog for Asia (PDF: 532KB)
